Creating fillets
You can transform any corner point in existing geometry into a fillet.
To create a fillet:
-
Select the fillet tool from the Sketch view toolbar or the Draw menu.
-
Select the point at the corner you want to transform into a fillet.
-
The corner point is transformed into a fillet, as shown in the example below.
Note that:
-
Transforming the corner point into a fillet results in a new arc with tangency constraints to the connected lines.
-
The arc has a radius of 10 by default, but may be changed if desired.
-
The constraints added to the sketch for the fillet do not affect your DOF.
-
Any dimensions associated with the corner point, such as the linear dimension on the left in our example, continue to be measured to the corner point.