Nous nous excusons: cette page n'a pas été traduite.
Back to Top
Complete, integrated model information
Enventive Concept enables engineers to embed formulas computing functional properties in component models, as shown in the spring model below. Engineers can simultaneously examine and modify graphical and mathematical views of their model. Changes are automatically reflected throughout the model, in the sketch, equations, and parameters, so you never have to worry about keeping data in sync.
Integrated equations compute properties
The equations for computing the spring properties are an integral part of the spring. The equations shown below are contained in the Spring_mm subcomponent that is being used in the SpringBottoming_Assy assembly. We can drive the values of the parameters contained in the Spring_mm subcomponent from the assembly and vice versa. Notice that the equations contained in the Spring_mm subcomponent include equations that set values for various parameters, such as the wire diameter, solid height, number of turns, spring diameter, and so on.
Tolerance analysis identifies contributors
When the spring component is used in an assembly, tolerance analyses involving the spring will identify contributors from the spring equations, such as wire_diameter, as shown in the Contributor Info section of the tolerance analysis report below.
Matrix analysis identifies contributors common to all analyzed parameters
We can run tolerance analysis on multiple parameters in order to see a matrix of the contributors common to all the analyzed parameters. In the example shown below, we’ve analyzed a group of parameters, including SpringLength, Stress, and solidheight. Note that the contributors shown in this report reflect the contribution to the set of parameters we analyzed, not just individual parameters.
Optimizing critical parameters reduces variation
Using Enventive Concept’s Excel Solver add-in, optimization may be run directly from the tolerance analysis report.
In the illustration below, the solver has been set up to minimize variation (minimize Sigma) by changing contributor values, including wire_diameter, Freelength, Number_active_turns, and Spring_diameter. Boundaries (constraints) have been specified for these parameters to drive the Sigma value. We’ve also specified target values for the analyzed parameters: Spring_Length must equal 85.0, Stress must be less than or equal to 490.0, and solidheight must be less than or equal to 50.
As shown below, the optimization finds nominal values that meet the target performance goals while minimizing variation. Note that the Spring_Length, Stress, and solidheight parameters meet the specified target values, and variation has been reduced significantly, all without tightening tolerances.
Back to Top
Enventive Concept software enables engineers to rapidly analyze force across a range of motion at the push of a button. Analysis results are recorded directly to Excel for quick and convenient plotting.
To see how Enventive Concept helps engineers analyze force, consider the following example. Government regulations specify a minimum force to open the door of a laundry dryer, which is secured with the latch mechanism shown below.
Although it is vital to meet the minimum force requirement, it is also vital that the force not be too high, making the door difficult to open. The optimal solution will reliably meet the minimal force requirement with minimal variation, because excessive variation may cause the force to be either too high or too low.
The Enventive model shown above was used to simulate the force on the door latch as the door was opened. The force will initially increase as the door is pulled. It is important to determine the variability of the force across the range of motion, and the point at which the force peaks.
Enventive Concept enables engineers to rapidly analyze the force across the range of motion. The plot near the bottom of the image shows the nominal force value as well as the +/- 3 sigma force variation due to tolerance variations. At the push of a button, Enventive Concept is able to analyze the entire range in less than a minute.
Analysis results are recorded directly to Excel where they can quickly be plotted using tools provided by Excel. Excel is embedded directly in Enventive Concept, and may optionally be run in its own window while maintaining its connection to Enventive Concept. Excel is used for all tolerance analysis reporting, and may be used to drive Enventive models as well. Excel data is saved inside the Enventive data files.